Acura 2008 TL - Owner's Manual - Manual (Page 116)

If your vehicle’s battery is
disconnected or goes dead, or a front
window fuse is removed, the AUTO
function is disabled. The power
window system needs to be reset
after reconnecting the battery or
installing the fuse.
Start the engine. Push down and
hold the front window switch until
the window is fully open.
Pull and hold the front window
switch to close the window
completely, then hold the switch
for a second or two more.
If the power windows do not operate
properly after resetting, have your
vehicle checked by your dealer.
If either front window runs into any
obstacle while it is closing
automatically, it will reverse
direction, and then stop. To close the
window, remove the obstacle, then
use the window switch again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.
To close either front window fully,
pull back the window switch firmly
to the second detent, then release it.
The window automatically goes all
the way up. To stop the window from
going all the way up, push down on
the window switch briefly.
When you push the MAIN switch in,
the switch is off, and the passengers’
windows cannot be raised or lowered.
To cancel this feature, push on the
switch again to get it to pop out.
Keep the MAIN switch pushed in
when you have children in the
vehicle so they do not injure
themselves by operating the
windows unintentionally. 1.
2.
Auto Reverse
Power Windows
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
113
2008 TL
Table Of Contents Main Menu