the image) until the top of the jack contacts
the jacking point. Make sure that the jacking
point tab is resting in the jack notch. Do not
overextend the jack.

3. Raise the vehicle, using the jack handle bar and

the jack handle, until the tire is off the ground.

The following instructions must be followed to use the jack safely:

• Do not use the jack with people or luggage in the vehicle.
• Use the jack provided in your vehicle. Other jacks may not support the weight

(“load”) or fit the jacking point.

• Do not use while the engine is running.
• Use only where the ground is firm and level.
• Use only at the jacking points.
• Do not get in the vehicle while using the jack.
• Do not put anything on top of or underneath the jack.

The vehicle can easily roll off the jack, seriously injuring anyone underneath.
Follow the directions for changing a tire exactly, and never get under the
vehicle when it is supported only by the jack.

WARNING

Jack
handle bar

Wheel nut

wrench as

jack handle

Do not use the jack if it doesn’t work properly. Call your dealer or a professional
towing service.

NOTICE

Replacing the Flat Tire

1. Remove the wheel nuts and flat tire.

2. Mount the compact spare tire. Replace the

wheel nuts, and lightly tighten them.

3. Lower the vehicle and remove the jack. Tighten

the wheel nuts in the order indicated in the
image. Go around, tightening the nuts, two to
three times in this order. Do not over tighten the
wheel nuts.

Storing the Flat Tire

1. Remove the center cap, and place the flat tire

face down in the spare tire well.

2. Remove the spacer cone from the wing bolt,

flip it over, and insert it back on to the bolt.
Secure the flat tire with the wing bolt.

3. Return the jack and wheel nut wrench to the

tool case. Store the case in the trunk, and
close the trunk.

Loose items can fly around the interior in a crash and can seriously injure the
occupants.
Store the wheel, jack, and tools securely before driving.

WARNING

Wing bolt

Spacer

cone