When a vehicle is detected in your blind spot, the
blind spot indicator turns on and stays lit until the
area is clear.
When your turn signal is on and a vehicle is
detected, the blind spot indicator blinks and a
beep sounds until the area is clear or the turn
signal is off.

Changing BSI Settings

Change the alert type, or turn the system on or off. Use the interface dial to make
selections.

1. Press SETTINGS.
2. Select Vehicle Settings. The vehicle must be in

Park (P).

3. Select Blind Spot Info.
4. Select an alert type, or Off.
5. Press BACK to exit the menu.

Important Safety Reminder
Like all assistance systems, BSI has limitations. Over-reliance on BSI may result in a
collision. The system is for your convenience only.

Failure to visually confirm that it is safe to change lanes before doing so may
result in a crash and serious injury or death. Do not rely only on the blind spot
information system when changing lanes.
Always look in your mirrors, to either side of your vehicle, and behind you for
other vehicles before changing lanes.

WARNING

BSI alert

indicator

*if equipped

Road Departure Mitigation (RDM) System*

A camera mounted between the windshield and the rearview mirror determines
if your vehicle begins to cross over detected lane markings while driving between
45–90 mph (72–145 km/h).
If you get too close to a
detected lane line without
using your turn signal, a
message appears in the MID.
Steering wheel torque and
vibrations are applied to help
your vehicle stay in the lane.
Braking may also be applied
if the lane lines are solid and
continuous.

Turning the System On or Off

Press the RDM button to turn the system
on or off. A green indicator appears on the
button
when the system is on.

Changing Settings

Determine the warning timing, or turn the system off. Use the interface dial to
make selections.

1. Press SETTINGS.
2. Select Vehicle Settings. The vehicle must

be in Park (P).

3. Select Road Departure Mitigation System.
4. Select from the options.

Normal (default): Steering control starts from inside the lane edge.
Wide: Steering control starts from outside the lane edge.
Warning Only: The system only provides a BRAKE message, but does not apply
steering or braking.

5. Press BACK to exit the menu.

Important Safety Reminder
The system has limitations. Overreliance on it may result in a collision. It is always
your responsibility to keep your vehicle within the driving lane.

Lane departure

message

Audible

beep

Visual warning

*if equipped