Rotate the switches on the lever to operate the exterior lights. Push the lever
forward to turn on the high beams. Return the lever to its original position for
low beams.
OFF

All exterior lights are off.

AUTO

Turn on the automatic lighting

feature. Headlights turn on or off

depending on ambient brightness

when the vehicle is on.

Headlights automatically come

on after the wipers are engaged

for a certain time.

Turn on exterior lights except

headlights.

Turn on all exterior lights including headlights.

Turn fog lights on or off.*

Brightness Control

Adjust instrument panel brightness when the vehicle is on.

To brighten:

Press the + button.

To dim: Press the - button.
A beep sounds when the brightness reaches
minimum or maximum.

Bright

Dim

Interior Lights

Lights are located on the ceiling.

ON position: Interior lights remain on.
Door-activated position: Interior lights come on
when any of the doors are opened, the driver’s door
is unlocked, or the vehicle is turned off.
OFF position: Interior lights remain off.

Door-

activated

position

Off

Flashing high beams

Low beams

High beams

Fog lights*

*if equipped

One-Touch Turn Signal

Use this quick and convenient method to signal a lane change.

• Lightly push the turn signal lever up or down

for a three-blink sequence.

• For a continuous signal, push the lever up or

down until it locks into place.

Right

Left

*if equipped

Wiper Operation

The windshield wipers and washers can be used when the vehicle is on. Move the
wiper lever up or down to the desired position.

Headlight-Wiper Integration

When the headlights are in the AUTO position,
they automatically turn on when the front
wipers operate several times within a certain
interval. The headlights turn off shortly after
the wipers are turned off, or if there is enough
ambient light.

Intermittent Wipers*

When you move the lever to the INT position,
the wipers operate based on the delay
adjustment.
Adjust the wiper delay using the intermittent
time adjustment ring.

Automatic Rain-Sensing Wipers*

When you move the lever to the AUTO position while driving in rainy weather,
the wipers operate based on the amount of detected rainfall.
Adjust the rainfall sensor sensitivity using the intermittent time adjustment ring.

Always ensure the wiper lever is in the OFF position before entering a car wash to
prevent severe damage to the windshield wiper system.

Mist
Off
Intermittent*/automatic*
Low speed
High speed

Intermittent time

adjustment ring

Pull for

washer.

NOTICE