Culligan Iron-Cleer Plus - Manual (Page 21)

17
Complaint Problem Cause Solution
Water is
running
to drain
continuously.
A. Control valve is
stuck in regeneration
cycle.
1. Electrical service
to control(s) has been
interrupted.
1. Assure continuous
electrical service is
available. (check plug,
breaker, fuse, etc.)
2. Faulty circuit board. 2. Replace circuit board..
3. Faulty drive motor. 3. Call your Culligan dealer
for service.
4. Foreign material lodged in
piston.
4. Call your Culligan dealer
for service.
Blue green
staining.
A. Corrosive water
condition in copper
distribution piping
system.
1. Low pH condition of the
raw water supply.
1. Call your Culligan dealer
for service.
2. In rare occasions, highly
aerated water in combination
with a specific water supply
can create a slightly corrosive
condition.
2. Call your Culligan dealer
for service.
Compressor
doesn’t run.
1. Compressor unplugged. 1. Plug it in.
2. Relay settings incorrect. 2. Call your Culligan dealer
for service.
3. Bad relay. 3. Call your Culligan dealer
for service.
Compressor run
with excessive
noise.
1. Dead head pressure is 65
psi.
1. Call your Culligan dealer
for service.
2. Dead head pressure is 65
psi.
2. Call your Culligan dealer
for service.
Compressor
runs
continuously.
1. Incorrect relay settings 1. Call your Culligan dealer
for service.
2. Bad relay. 2. Call your Culligan dealer
for service.
Troubleshooting
Guide (cont.)