Culligan Iron-Cleer Plus - Manual (Page 14)

10
The statistical functions are reached by pressing the “Information” key. Repetitive presses of the
“Information” key will cycle through the standard statistics mode until cycled back to time of day
display. Once either of the Information menus is entered the information shown for each display is
outlined below:
• Flow Rate - This display will only show if the flow meter is
attached to the control. The display shall show the current flow
rate of the water passing through the control. The display will
show the “Flow Rate” and “GPM” icons and the current flow
rate passing through the flow meter for as long as the “-” key or
“Information” key is not pressed.
• Capacity Remaining (%)(standard statistics) - This
display will only show if the flow meter is attached to the control.
The display shows the percent capacity remaining before
regeneration will be triggered. The display will show the “Water
Usage”, “Remaining” and “%” icons.
• Today’s Water Usage - This display will only show if the
flow meter is attached to the control. The display will show the
accumulated flow of water for the current day. The value is to
start totalizing at 12:00 AM and reset to 0 at 11:59:59 PM. The
display will show the “Today’s”, “Water Usage” and “Gallons”
icons and the total days flow.
• Average Daily Water Usage - This display will only show if
the flow meter is attached to the control. The display will show
a running 7-day average of daily water usage. The display will
show the “Avg Daily”, “Water Usage” and “Gallons” icons and
the averaged flow value.
Statistic
Functions
%