Kimber Solo - Manual (Page 39)

CLEANING
Always insert the cleaning rod from the chamber end
of the barrel.
1. Disassemble firearm as described in previous
section.
2. Push a wet patch through the barrel bore. Let
soak a few minutes. (Always read and follow
the manufacturer’s directions for the bore
cleaner being used).
3. Push a dry patch through to remove loose
debris/ deposits.
4. Push a wet bore brush through the chamber
end of the barrel make several passes.
5. Push a dry patch through to remove debris.
6. Repeat steps 4 and 5 until the patch comes
out clean.
7. Lightly oil the barrel. NOTE: Push a dry patch
through the barrel before firing to remove oil.
8. Wipe off all dirt on all bearing surfaces on
slide and frame.
9. Clean breech face and all parts (an old
toothbrush or similar nylon brush works well).
10. Follow lubrication directions before
reassembling.
39