Hardy HI 6500 Series - Manual (Page 5)

Initial Set‐Up:
Set Up may be performed through the front panel display or through
the integrated Webserver. If setting up using the Webserver, first
connect an Ethernet cable between the instrument and and then follow
the Communications>Ethernet TCP/IP instructions below.
Suggested flow when setting up the instrument for the first time:
If setting up an instrument without a display for the first time, skip to
the communication section below.
SET UP (minimum)
1) Unit
2) Capacity
3) Grads
4) Decimal Point
5) Motion Tolerance
Filter
1) Num Averages
2) Waversaver
Calibration
1) Cal Date
2) Cal Method
a. C2 eCal
b. Hard Cal
3) Complete Cal
Procedure