faytech Industrial Motherboard Series - Manual (Page 25)

8.
These connectors connect to Serial ATA 3Gb/s hard disk drives and optical
drives via Serial ATA 3Gb/s signal cables.
SATA3G_2
Serial ATA 3Gb/s connectors (7-pin SATA3G_1/2])
faytech Industrial Motherboard Series SATA 3.0Gb/s connectors
NOTES:
•
•
•
These connectors are set to [IDE] by default. In IDE mode, you can connect
Serial ATA boot/data hard disk drives to these connectors.
You must install Windows
®
XP Service Pack 3 or later version before using
Serial ATA hard disk drives.
When using hot-plug and NCQ, set the Configure SATA as item in the
BIOS to [AHCI]. See section 3.4.2 IDE Configuration for details.
9.
This connector is for the SATA power cable. The power cable plug is
Designed to fit this connector inonly one orientation. Find the proper
Orientation and push down firmly until the connector completely fit.
SATA power connector (4-pin SATA_PWR1)
SATA_PWR1
+5V
GND
GND
+12V
faytech Industrial Motherboard Series SATA power connector
Chapter 2: Motherboard information
GNDRSATA_RXP1RSATA_RXN1GNDRSATA_TXN
1RSATA_TXP1GND
GNDRSATA_TXP2RSATA_TXN2GNDRSATA_RXN
2RSATA_RXP2GND
SATA3G_1
2-17