Doepfer A-112 Sampler/Wavetable Oscillator - Manual (Page 4)

A-112 Sampler System A - 100 doepfer
4
3. Controls
1 Atten.
Control 1 attenuates the level of the voltage at input
!
. Depending upon the mode this voltage is the audio
signal (in sampling or effect mode) or the wavetable
control voltage (in wavetable mode).
2 Tune
The tune control 2 is used to adjust the sampling
frequency (during record) or the pitch/tune during
playback (see table below).
Exception: In wavetable record mode one of the 256
pages is selected with the tune control (see following
table). In this case the sampling frequency defaults to
the last frequency that was set prior to switching into
wavetable mode.
H The voltage generated with the tune control
is internally added to the voltage at input ".
This input is normally used to control the
pitch of the sampler/wavetable oscillator in
play mode with an external control voltage
following the 1V/oct standard (e.g. the A-190
MIDI-to-CV interface).
3 Run
LED 3 is used for different monitoring purposes
depending upon the mode selected. A description of
the respective function is given in the corresponding
paragraph elsewhere in this manual.
4 Man. Trig.
Button 4 is used to trigger the sampler manually.
Depending upon the mode selected a Trigger or Gate
leads to different actions. A description of the
respective functions is given in the corresponding
paragraph elsewhere in this manual.
H The manual trigger generated with button 4
and the signal at the gate input § are inter-
nally connected, to produce a gate/trigger
signal used for all triggered/gated functions.
tune
position
page
(appr.)
sampling-
freq. [kHz]
tune-
position
page
(appr.)
sampling-
freq. [kHz]
0 0 2,0 6 154 18,5
1 26 2,9 7 179 26,5
2 51 4,2 8 205 38,5
3 77 6,1 9 231 56,2
4 103 8,8 10 255 79,4
5 128 12,7
The data in the table are approximate values