Cub Cadet MTD P71 Series - Manual (Page 102)

P71 Series Vertical Shaft Engines
96
Bearings
There are two bearings to inspect; a plain bearing in the
sump and a ball bearing in the cylinder block. To inspect
the bearings:
1. Remove the sump and cylinder block oil seals using
a seal puller. See Figure 10.22.
2. Inspect the bearing surface for galling, scratches,
metal transfer or any other signs of damage.
3. Measure the inside diameter of the bearings and
compare to the chart at the end of this chapter. See
Figure 10.23.
Figure 10.22
Cylinder block oil seal
Seal puller
Figure 10.23
Measure the
bearing ID