Vermont Casting VM508 - Manual (Page 8)

50004425
E. ELECTRICAL SAFETY
• Always confirm that this Grill has been grounded in accordance with applicable local Codes or, in the absence of
local Codes, with the National Electrical Code, ANSI/NFPA No. 70 or the Canadian Electrical Code, CSA C22.1,
when an external electrical source is being utilized for the Rotisserie Motor.
1. Never immerse the power cord or power plug in water, or in any other liquid to protect against electric shock;
2. Always unplug the power cord from the outlet when not in use, and before cleaning the Grill. Always allow the
unit to cool before installing or removing any Rotisserie components;
3. Always contact the manufacturer for necessary repair services, if the unit has malfunctioned or has been damaged in
any manner, and never attempt to operate the unit with a damaged power cord or power plug;
4. Never allow the power cord to contact a hot surface or to hang over the edge of a table, where it might sustain dam-
age;
5. Never use this Grill for any purpose other than the ones specifically intended by the manufacturer;
6. Always connect the power cord to the Grill first, and then plug it into the power outlet;
7. Always connect this Grill to an electrical circuit protected by a Ground Fault Interrupter (GFI);
8. Never remove the 3-pronged (grounded) power plug from the existing Rotisserie Motor power cord, and never con-
nect the 3-pronged (grounded) power plug to a 2-pronged adapter.
9. If it is necessary to use an extension cord, always select one that has a 3-pronged (grounded) power plug; that is
adequate for the power rating of the unit; and that has been approved for outdoor use, and has a W-A marking.
10. Keep any electrical supply cord and the fuel supply hose away from any heated surface.
11. Electrical Grounding Instructions: This outdoor cooking gas appliance is equipped with a three-pronged (ground-
ing) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-
pronged receptacle. Do not cut or remove the grounding prong from this plug.
F. BATTERY HANDLING
Replacing the battery incorrectly might result in an explosion. Replace the battery only with the same or equivalent
type recommended by the manufacturer. Dispose of used batteries according to your local environmental guidelines.
WARNING
Page vi
Safety
WARNING