beautypg.com

Operation, Lighting the main burners – Vermont Casting VM508 User Manual

Page 15

background image

50004425

Page 7

Lighting the Main Burners

Never stand directly over the Grill when lighting the main burn-

ers, to avoid exposure to possible flare-ups.
1. Always open the Hood completely and always inspect the

Grill and burners before lighting the main burners.

2. Always confirm that all of the burner control knobs are in

the OFF position before opening the gas supply.

3. Turn on the Propane Tank Valve at the tank (1 to 2 turns)

(Fig. 8)or turn on the main natural gas supply valve.

4. Turn the selected Burner Control Knob to the HIGH posi-

tion by pushing down on the knob and turning it counter-

clockwise.

5. Immediately activate the Igniter. (Refer to Page 6) The

selected burner should light within five seconds. Light the

burners sequentially from either left to right or right to left.

IF THE SELECTED BURNER DOES NOT LIGHT,

immediately turn the burner control knob to the OFF

position, to prevent gas buildup. Wait five (5) minutes for the

gas to clear and then repeat the preceding

starting procedure. If the burner will not light when using the

Igniter, follow the match lighting instructions.

(Refer to Page 8)
6. Confirm that the burner is properly lit and the flame pattern is as desired. Refer to Figures 9a, 9b & 9c, for the

proper flame patterns. If the flame pattern is other than normal, consult the Troubleshooting Guide on Page 23 for

corrective action.

7. Always preheat the grill before starting cooking. A light coating of cooking oil on the cooking grids, before heating

the Grill, will prevent foods from sticking to the Grill. Light all burners and adjust them to the HIGH position for

5 to 10 minutes. Before placing any food on the Grill, clean the cooking grids with a brass wire brush.

8. Adjust the Controls to a medium setting for most cooking requirements.

����
���������������������
����

Figure 9a

Figure 9b

Figure 9c

Normal: Soft blue flames

Out of Adjustment: Noisy, hard blue
flames indicate too much air

Poor Combustion: Wavy, yellow flames
indicate too little air.

B129

NOTICE: When lighting the grill for the first time, burn with the

main burners on HIGH for at least 30 minutes, to burn off any

manufacturing residues.

Figure 8

B178

����
������������
����

WARNING

Operation

This manual is related to the following products: