beautypg.com

Operation – Vermont Casting VM508 User Manual

Page 19

background image

50004425

Operation

Page 11

Lighting the Side Burner (if applicable)

Never stand directly over the Grill when lighting the main burners, to avoid exposure to possible flare-ups.
1. Ensure the main Propane Tank Valve or the main Natural Gas supply valve arein the on position. Turn the side

burner control knob to HIGH. (Fig. 13)

2. Push and hold the Igniter Button, you will hear a series of clicks as the igniter module generates an ignition spark

to the burners. The burner should light within five seconds. (Refer to Page 6)

3. Check the flame pattern. Soft blue flames are normal, hard blue flames or wavy yellow flames are not. Adjust the

flame pattern with the air shutter below the control knob. (Fig. 19, as necessary. If yellow flames persist, refer tot he

Troubleshooting Guide on Page 22.

SHUTTING THE BURNER OFF

Turn the control knob counterclockwise to the HIGH position, then depress it and turn it to OFF.

NEVER apply force to the control knob without depressing it, as that can damage the valve.

����
�����������
����

B169

Figure 13

WARNING

NOTICE

Rotisserie Setup

(continued)

Never attempt to use the rotisserie burner for any purpose other than rotisserie cooking.

Never use the main burners while using the Rotisserie burner, as that could result in igniting the drippings, or over-

heating your Grill.

Never use the Rotisserie Motor in the rain, and never use it if it has become wet.

Always use a grounded three-prong outlet and a three-prong extension cord to energize the Rotisserie Motor. Never

alter or remove the grounding prong on the Rotisserie Power Cord, as an electric shock hazard would then result.

Keep any electrical supply cord and the fuel supply hose away from any heated surface.

Electrical Grounding Instructions: This outdoor cooking gas appliance is equipped with a three-prong (grounding)

plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong

receptacle. Do not cut or remove the grounding prong from this plug.

WARNING

This manual is related to the following products: