Cub Cadet 190-291-100 - Manual (Page 17)

17
Figure 30
INSTALL NEW SPINDLE BELT
1. Lift the gear box/ mounting bracket assembly to
install the belt around the rear and left side of the
drive pulley, and through the center opening of the
mounting bracket.
2. Secure the gear box mounting bracket to the deck
with the four carriage bolts and hex flange lock
nuts.
3. Route the backside of the belt around the rear and
right side of the movable flat idler pulley.
4. Loop the belt and slide it under the LH belt cover
mounting strap.
5. Route the belt as follows:
• around the left spindle pulley
• around the rear of the fixed flat idler pulley
• around the front of the center spindle pulley
• to the right spindle pulley
6. After making certain the belt is properly engaged in
each pulley, pivot the movable flat idler pulley
toward the left side of the deck to loosen belt
tension and allow the spindle belt to be rolled onto
the right hand spindle pulley.
7. Install the belt covers and secure with the thumb
screws and bell washers.
1.
2.
3.
4.
5. 7.
8.
9. Spindle Pulleys
Movable Flat Idler Pulley
Drive Pulley
Fixed Flat Idler Pulley
Spindle Belt Idler Bracket
Gear Box Mounting Bracket
Idler Spring
1
1
2
3
4
5
6
7
8
9
10
11
1
LH Belt Cover Mounting Strap 6.
10.
11. Carriage Bolts and Flange Lock Nuts
Carriage Bolts and Flange Lock Nuts