COP-USA WS08 - Manual (Page 36)

Network Video Server/IP Camera User Manual
36
Probe Warning Setting
Step I: Connect hardware; connect the alarm input equipment with the alarm
Input port of DVS/IP Camera correctly
Step II: Open the probe alarm setting interface as picture above
Step III: According to the type of probe, select『Probe ID and Type』, and
define the『Probe ID and Type』by self
Step IV: 『Set Arming Time of Probe』, select 『Start』, and set time segment
Step V: Set『Time of Alarm Elimination』(1~1800 seconds optional)
Step VI: 『Initiate Auto Snap-shot』 (optional)
Set the trigger of probe, then snap-shot image of any channel and transmit
afterwards
Step VII: Tick and select『Preset Channel』(optional)
When the probe is triggered, system will automatically move the dome camera to
designated『Preset Position of PTZ』