COP-USA DVRHPEG-8 - Manual (Page 61)

Digital Video Recorder User Manual
Fig 4.10 Alarm Out Configuration
Alarm out: set relay alarm out channel. You can select any alarm channels.
To record: set recording channels. You can select any record channels. It will record the cameras you choose here when
set and cruise for alarm. You can select any channel and multi channels as linked channels.
Alarm in holding time(S): the interval time between the two adjacent efficient sensor alarms. If a second alarm is
detected in Hold time again, it is recognized as a continuous alarm. If a second alarm is detected after hold time, this alarm
and the previous are recognized as two different alarm events.
Alarm out holding time(S): set relay alarm out time after alarm triggered.
Buzzer holding time(S): set on board buzzer time after alarm triggered.
4.2.6 Motion Configuration
Click MOTION to enter motion configuration as Fig 4.11 Motion Configuration.
alarm triggered.
Buzzer: enable buzzer on board for alarm.
To P.T.Z CH: set linked pre
55