ChemoMetec NC-200 - Manual (Page 34)

8 PC- maintenance, Error messages and Power-on failure
991-0203 Rev. 1.1 Sep. 2012 20
Figure 14. Location and removal of the fuse
Disconnect the power supply from the NucleoCounter. Then remove the fuse holder using
a screwdriver as indicated in Figure 14 (turn counter clock wise). Inspect the fuse. If it
needs replacement use one as described by ChemoMetec A/S.
If the NucleoCounter NC-200 does not turn on after replacement of the fuse, or if the fuse
was not broken, please contact ChemoMetec A/S or the local distributor for further
instructions.