ChemoMetec NC-200 - Manual (Page 25)

4 Start-up
991-0203 Rev. 1.1 Sep. 2012 11
4 Start-up
4.1 Power on, power off
On the rear of the instrument, two plugs and one fuse holder are located. When seen from
the rear the USB 2.0 port is to the left and the fuse holder and DC Pow er Plug is at the
right. The NucleoCounter NC-200 is powered by a 24VDC external power supply. To
connect the power supply to the NucleoCounter, connect it to the DC Power Plug (see
Figure 5), and plug the mains power cord of the power supply into a wall outlet.
Figure 5. Rear side of the NucleoCounter NC-200
The NucleoCounter NC-200 is turned “On” once the wall outlet is “On”. To power it “Off”,
either remove the DC Power Plug or turn the wall outlet “Off”.
Figure 6 USB 2.0 Figure 7 DC Power Plug