ChemoMetec NC-200 - Manual (Page 30)

5 Operation of the NucleoCounter
991-0203 Rev. 1.1 Sep. 2012 16
The events registered as cells can (when enabled in the protocol) be inspected by
launching the Protocol Adaption Editor in the Tools menu and selecting to show events
included in the count prior to running an analysis. This will launch a plot manager that
shows a scatter plot with a gate that encloses the events recorded as cells. Furthermore,
two histograms will be displayed showing the intensity and area of the events in the
picture.
Figure 12 The Plot Manager showing a scatter plot and two histograms
A USB Flash drive supplied with the instrument contains the software, drivers, instrument
specific data etc. On the same USB Flash drive you can also find the NucleoView NC-200
User’s Guide. Run the file “Install_Guide.html” and follow the directions to th e NucleoView
NC-200 User’s Guide. Once the program is installed the NucleoView NC-200 User’s Guide
can be displayed by following the directions: Menu – Help – Help Topics.
Refer to the NucleoView NC-200 User’s Guide for additional information.