Checkline BLL - Manual (Page 7)

 Electromatic Equipment Co., Inc.
-10-
12.0 PRINT SAVED DATA
(Only possible with USB interface module in combination with the Checkline thermo
printer)
To print your saved data, connect the device to the
printer using the printer cable that was delivered with
your device. Carefully loose the protection cap on the
BLL. At first plug in the side of the connector with the
close plastic casing at the BLL. Then switch on the
device.
Not till then the other side of the cable has to be
plugged in at the printer. Switch on the printer by
pressing
. Now the green LED is blinking. If it does
not blink, please change the batteries and try again.
Press the
button at your moisture meter until you
reach the menu (see image on the right). Choose „Print
Logs“ and confirm by pressing .
Now you can select if you want to print the last saved
measuring series or all saved measuring series (logs).
Confirm by pressing
again. The selected logs are
printed out now.
To save paper, please think of clearing the data
storage regularly.
 Electromatic Equipment Co., Inc.
-7-
8.0 RUNNING THE INSTRUMENT
Switch on:
Press the key for 3 seconds
Set the clock: Press 3 times the key -> Options -> Date/Time
Save measuring value: Save the measuring value by pressing the button below
the
symbol. The storage was successful when the
number in front of the symbol increased. To name
the saved results press the button.
Hold measuring value: At first activate the function in the menu Options ->
Datalog time by choosing “Hold”. Then press the left key
until appears. Press the key. The measuring
value remains on the display until another button is
pressed.
Display lighting: Press the key; Backlight will turn off automatically
after 30 seconds. Backlight will be activated by pressing
any key.
Power off: Press the key for 5 seconds; the device will be
switched off when you leave the key. The device also
switches off automatically when no key is pressed for 4
minutes.
Measuring range limit: If the measuring value is blinking,
the
valid measuring range is
exceeded. In this case the accuracy
will be decreasing.
Rotate display: This function rotates the complete
display. If you press the button
in
the additional function menu the
display will rotate.