Checkline FD-50R User Manual
Page 3
- 3 -
2.0 M
ULTIFUNCTIONAL DISPLAY
1.
Active reference indicator (REFI or REFII)
2. Measured
value
3.
Battery life warning display
4.
Indicating cursor for preset
5.
Unit of measurement indicator
0
6.
Locked mode indicator
0
7. Hold
indicator
0
8.
Display .0005/.00005 INCH
0
9. Preset
indicator
10.
Preset mode indicator
3.0 F
UNCTIONS
3.1 How to use buttons
3.2 Operation
Press for less than 1 second to activate button function.
Press for more than 1 second to activate mode change.
Mode
< 1sec
< 1sec
Mesure
Preset
mm
inch
Set
Digit = digit + 1
Ref I
Ref II
References
> 1sec
> 1sec
Off
Off
On
= 1sec
DIR
RES
MODE0
MODE1
On
MODE
SET
MODE
SET
Incr. digit
0.1.2...9
-000.123
Data out, hold
> 3 sec
RESET
(MODE 1, 2, 3)
- 10 -
8.0 S
PECIFICATIONS
Measuring range
0-12.5 mm / .5"
0-25 mm / 1"
Resolution
0.001 mm / .00005" (0.01 mm / .0005")
Accuracy
5µm (.0002") / 10µm (.0004")
NOTE: The accuracy is guaranteed only when the dial
gauge is attached to the clamping shaft.
Repeatability
2µm or .0001" (+/-2s)
Max. probe travel speed
1.5 m/sec.
Number of measurements
per second
0.01 mm
8 measurements/sec.
0.001 mm
5 measurements/sec.
Measuring force
0.6 to 1.1 N for 0-25 mm (1")
0.7 to 0.95 N for 0-12.5 mm (.5")
Units of measurement
metric/imperial (inch) (direct conversion)
Maximum preset
±2999.99 mm / ±89.9995 in.
Measuring system
SYLVAC system (patented).
Display
Digital LCD
sign (–), 6 digits (7 in.) height 8.5 mm,
(0.05 mil in inch), display of unit and operating mode.
Power
1 lithium battery 3 V, type CR2032, capacity 190 mAh.
Battery types
Toshiba CR2032 / Maxell CR2032
Renata B/CR2032 / Sanyo CR2032
Ucar CR2032 / Panasonic CR2032
Rayovac CR2032 / Varta CR2032.
Power consumption
60 µA.
Battery life
1 year or > 3000 hours with normal use When “B” is
displayed, the remaining battery life is several hours.
Working temperature
+5 to +40 °C.
Data output
RS232 compatible format.
Interface
RS232 interface cable, with optical coupling.
Construction
aluminium case, polyamide rotating dial (270°),
hardened and ground stainless-steel measuring spindle
Clamping
lower bushing diameter 8 h6 mm .
Contact point
M 2.5 interchangeable.
Protection
IP 51 (according to IEC 529).
Weight
130 g.
Accessories
OPTO-RS232 connector, 2m cable, duplex connection
for PC-AT (Dsub 9p) External power supply
(+5.0Vdc to +12.0 Vdc), binder connector 719 (3p)