Checkline FD-50R User Manual
Page 2
- 2 -
1.0 I
NTRODUCTION
The Electromatic dial gauge can be used as a replacement for mechanical dial gauges,
thanks to external dimensions conforming to the various standards for this type of
instrument. The functions of the Electromatic dial gauge are as follows:
• change units mm/inch
• change zero point for any probe position
• enter a reference value other than 0.000 mm (preset)
• possibility of measuring with two different references
• store measurement (display hold)
• transmission of measurement to a statistical processing system
The dial gauge has three operating modes, which are selected by pressing the [mode]
button for more than 1 second. The functions of each mode are activated by momen-
tarily depressing (< 1 sec) the [set] or [mode] buttons.
The Electromatic dial gauge is equipped with an OPTO-RS compatible data output.
1.1 Overview
1. Lifting cap (M2.5 interchangeable)
2. 8 mm clamping shaft
3. Contact point (M2.5 interchangeable)
4. Rotating dial (270°)
5. Cover for OPTO-RS connector
6. Pull-out slide for battery replacement
7. Multifunctional LCD
8. [mode] button
9. [set] button (ON/OFF)
- 11 -
9.0 R
EFERENCE
M
ODE
Measurement according
to reference I
Measurement according
to reference II