Checkline TS2P User Manual
Page 7
– 6 –
3.0 OPERATING PROCEDURES
3.1 Mounting Arrangements
TS2 Series sensors can be mounted in different ways:
• Mounting by using the frontplate on a cylindrical hole (cut out 38.5 - 40 mm Ø)
• Mounting on a flat platform
M3 Screws
M4 Screws
3.2 Connector Assignment
NOTE: To assure immunity to random noise, the measuring head must be installed
so that it is insulated from ground (GND). The shield of the connecting cable must
be connected to the metal housing of the connecting plug.
Pin assignment viewed from outside:
1 - Vcc + 15 to 24 V DC regulated
2 - Ground
3 - Ground
4 - Signal output -
5 - Signal output +
1
3
Shield
2
5
4
Female socket M9