Checkline TST - Manual (Page 8)

Series TS Torque Measurement Test Stands
8
Load capacity 100 lbin [11.3 Nm]
Speed range 0.3 – 8.6 RPM (4 – 52º/s)
Speed variation with load ±0% (Stepper motor driven)
Maximum angular travel No limit
Manual adjustment 12º/knob rev
Angle indicator resolution 2º
Maximum slider travel 15.50” [394 mm]
Slider travel rate 1.05” [26.6 mm] / lever rev
Line voltage Universal input 80-240 VAC, 50/60 Hz
Fuse type 1.2 A, 250V, 3AG SLO BLO
Weight (test stand, only) TSTM: 35.5 lb [16.1 kg],
TSTMH: 29.5 lb [13.4 kg]
Control Unit weight 2.7 lb [1.2 kg]
Speed accuracy ±5% of setting
TSTM / TSTMH
Using the Control Unit
CCW
Press and hold for counter-clockwise motion, release button to stop. Located on
the face of the Control Unit.
CW
Press and hold for clockwise motion, release button to stop. Located on the face
of the Control Unit.
SPEED CONTROL DIAL
Adjust speed by turning the dial 0.3 – 8.6 RPM (4 – 52º/s). Located on the face
of the Control Unit.
POWER SWITCH
Use this switch, in the left rear of the Control Unit, to turn on and turn off power
to the test stand. Power is indicated by an amber light on the face of the Control
Unit.
POWER PLUG RECEPTACLE
Located in the left rear of the Control Unit. Plug the power cord in here.
CONTROL CABLE
Plug this cable into the lower male connector on the test stand, adjacent to the
motor.
SPECIFICATIONS