Checkline DI-1M - Manual (Page 2)

page 11 page 2
TORQUE MEASUREMENT TORQUE MEASUREMENT
SPECIFICATIONS
LIST OF EQUIPMENT
Torque Tester Display Unit
Torque Sensor
Cable
AC adapter/charger
Units designator
1
2
3
4
5
1
2
3 4
5
READ FIRST: SAFETY INFORMATION
For safety, and for damage avoidance, be sure to read this manual
thoroughly. The warranty is only valid when the product is used fol-
lowing the instructions provided within this manual.
l Do not use tester in high temperature, high humidity, or in
damp or wet areas.
l Recommended operating temperature is between 0-42ºC (32-
100ºF).
l Do not apply torque exceeding the rated capacity, regardless of
whether the unit is On or Off.
l When charging the battery, be sure to use the provided AC
adapter/charger exclusively.
l When measuring torque, the unit will have a tendency to turn. In
order to avoid spinning and possible accident, it is very impor-
tant to securely mount the unit to a stable work bench.
l Do not use lacquer thinner or any solvent to clean the unit.
l Do not disassemble or modify the unit.
Model lbf-in kgf-cm N-m
DI-1M-50 3.0~440.0 3.0~500.0 30~5000 (N-cm)
DI-1M-200A 30~1800 30~2000 3.0~200.0
Model lbf-ft kgf-m N-m
DI-1M-200 3.0~145.0 0.30~20.00 3.0~200.0
DI-1M-500 3.0~362.0 0.30~50.00 3.0~500.0
DI-1M Ranges Accuracy: ±0.5% F.S. ±1 LSD
DIMENSIONS
A B C D E F G
DI-1M-50IP ∅50 63 10 ∅90 ∅76 ∅6.5 9.5
(1.97") (2.48") (.39") (3.54") (2.99") (.26") (3/8" Female Drive)
DI-1M-200IP ∅60 72 10 ∅110 ∅90 ∅9.0 12.7
(2.36") (2.83") (.39") (4.33") (3.54") (.35") (1/2" Female Drive)
DI-1M-500IP ∅80 99 15.5 ∅140 ∅116 ∅10.5 19
(3.15") (3.89") (.61") (5.51") (4.57") (.41") (3/4" Female Drive)