Checkline QB-LED User Manual

Page 11

– 10 –

4.4 Pro Mode

Follow the steps below to access the pro mode:

1. Turn the selector switch (E) from OFF to the required position while

simultaneously

holding the rotary/push knob (D) until the PRO notification

appears in the display.

2. When the Pro mode is activated, a P appears in the bottom right area of the display

NOTE: If you have selected settings in Pro Mode and then switch the device off, these
settings will ONLY be active when the device is switch back on if pro mode is activated.
Otherwise, only the standard mode settings will be active.

No.

Position of the

Selector Switch

(E)

Adjustable

Parameters

Description

Display

(4)

FREQUENCY

FPM

Description: Frequency selection; FPM:

flashes per minute
-

Turning the knob while pushing

it simultaneously, the adjustment

increment is effected in steps of 100.
- The flash can be turned off by

pushing the knob once and turned on

again by

pushing the knob once again.

(1)

BRIGHT

BRIGHT deg

Selection of brightness

(in 1/1,000 degrees)

(3)

PHASE deg:

0…359

Delay setting between the trigger signal

and flash (in degrees relative to the

frequency

(10)

INT /EXT

Internal /external trigger

NOTE:

See also section 4.3 Standard Mode for examples and explanation regarding the above mentioned

display messages.