California Faucets Single Hole High Lavatory Faucet User Manual

Page 2

CF-E201-2_ii_140201.doc

Pg 2

TYPICAL DRAIN INSTALLATION

This faucet does not come with a drain because the typical lift

rod style drains are not practical for most vessel sinks. Vessel
sinks are very unique and therefore a standard drain is
generally not convenient. Cal Trim, a division of California

Faucets, offers a complete selection of styles (e.g. Umbrella,
Lift & Turn, Grid, etc…) and configurations (e.g. with/without
overflow holes and partially/fully polished & finished) to

compliment the range of vessel sinks available.

The following is a typical installation of Cal Trim’s Tough Style
Pop-Up Drain (9050L):

Remove COLLAR (9) from drain assembly and apply
SILICONE CAULK (10) (or equivalent) to underside of
COLLAR (9)

CAUTION: Do not use or any oil base sealant that may damage finish

Insert DRAIN BODY (12) from underside through sink
DRAIN HOLE (11) and attach to COLLAR (9)

Firmly tighten FLANGE NUT (15) against FRICTION
WASHER (14), MACK WASHER (13) and sink DRAIN
HOLE (11)

SUPPLY & WASTE CONNECTIONS

Connect blue colored FLEX HOSE (5) to cold SUPPLY
VALVE (16) and red colored FLEX HOSE (5) to hot
SUPPLY VALVE (16)

IMPORTANT: Flush supply lines and valves prior to installation to prevent
damage and malfunction of cartridge

Connect waste P-TRAP (17) to drain TAILPIECE (12a)

NOTE: Supply valves and P-Trap are not supplied with faucet. See CAL

TRIM for complete selection of matching products in desired finish

Turn on cold and hot SUPPLY VALVES (16)

Slowly open faucet lever by lifting lever and rotate to left
and right

Check all connections for leaks and repair as necessary

Give these instructions to consumer for safe keeping

NOTE: Occasionally, due to water conditions it may be necessary to
remove aerator and clean debris off with soft bristle toothbrush

calforniafaucets.com

5271 Argosy Ave. Huntington Beach, CA 92649

800-822-8855