California Faucets 4" Centerset Faucets - Manual

4" CENTERSET
***NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
INSTALLATION
INSTRUCTIONS
Handle
Set
Screws (x2)
Wing
Nut
Spout
Base
Fig. 2
Fig. 3
Stopper
Adjustable
Eye-Screw
Drain
Collar
Drain
Rim Rubber
Washer
Brass
Nut
Nut Ball
Rod
Drain
Tailpiece
Cone
Washers Spring
Clip
Hole
Rod
Strap
Lift
Rod
Wing
Nut
Lift
Knob
NOTE: Handles
not shown Base
Adjustable
Eye-Screw
Ball
Rod
Nut
1
Install faucet:
-Remove wing nuts from threaded shanks and insert faucet
through holes in sink or countertop. Re-attach the two
plastic wing nuts, align faucet, and tighten firmly from below.
2
Install Handles:
-Attach the handles to the body by tightening the set
screws using the allen wrench (provided).
Threaded
Shank
Fig. 1A
All 4" Centersets faucets meet A112.18.1 - 2.2gpm/8.31 L/min.
3
Lock
Nut
All products are engineered to provide quality performance provided
they are installed and operated properly. To fully enjoy the comfort, safety, and reliability of your
new Centerset, please follow the instructions below.
IMPORTANT
R
Tel: 714-891-7797
Fax: 714-891-2478
Toll Free: 800-822-8855
www.calfaucets.com
California Faucets reserves the right to make modification and specification changes at any time.
Please visit www.calfaucets.com for most current technical data.
Ref. CS-INSTL (V 01) 08/17/06 Continued
Fig. 1B
J Style Spout Traditional Centerset
Install pop-up assembly.
-Separate drain collar from pop-up assembly.
-Apply silicon caulking to underside of drain collar. NOTE: Do not use
"Plumbers Putty" or any oil based sealants! Use of anything other than
silicon caulking will VOID the finish warranty.
-Insert drain body from underside through sink. Slowly screw on drain
collar, align with ball rod hole facing back wall, then gently pull down into
sink and firmly tighten brass nut from below.
-Remove tailpiece from drain body and apply teflon tape, approx. 3 to
5 wraps around threads and reinstall into bottom of drain body.
-Insert stopper in collar and hold with eye-screw hole facing back.
If necessary, adjust stopper eye-screw height by loosening lock nut and
rotating counter-clockwise. Tighten lock nut (See Fig. 3).
-Remove spring clip from ball rod.
-Remove nut and cone washers and slide onto end of ball rod.
-Insert ball rod into drain body below so short end of ball rod end fits
in stopper eye-screw hole. Snug ball rod nut (do not over tighten).
Ball rod must move up & down freely (See Fig. 3).
-Insert lift rod through top of spout and then through hole rod strap
underneath sink. Tighten thumb-screw of hole rod strap
against lift rod and connect to ball rod by gently pinching locking
spring clip and sliding one side of spring clip onto ball rod.
-Insert hole strap onto ball rod, then pinch spring clip together to fit
on ball rod.