California Faucets Single Hole/Handle Bidet Faucet - Manual (Page 2)

Lift Knob
Hole Rod
Strap
Nut
Ball
Rod Cone
Washers
Fiber
Washers
Drain
Tailpiece
Rubber
Washer
Drain
Collar
Stopper
Drain
Rim
Adjustable
Eye-Screw
7
Nut
Brass
Nut
9
Fig. 9
Fig. 8
Fig. 9
Adjustable
Eye-Screw
Ball
Rod
Lift
Rod
Drain Tail piece
"P" Trap
(not supplied)
Angle Stop
(not supplied)
Spring
Clip
Lock
Nut
NOTE:
P-trap and angle stops are not supplied.
We recommend genuine
Cal-Trim parts available at your authorized
California Faucets dealer.
8
Fig. 8
-Connect your waste "P"
trap to the drain tail piece.
Flex
Line
Install "P" trap:
5
-Install rubber washer
and horseshoe washer.
Install washers: Tighten to surface:
6
Rubber Washer
Horseshoe Bracket
Brass
Nuts
-Screw on 2 brass nuts to
mounting rods.
-Hand tighten as you align
Bidet faucet.
-Firmly tighten nuts with a
deep socket or adjustable
wrench.
Mounting
Rods
Fig. 6
Fig. 7
IMPORTANT: Remove aerator, open
hot/cold water supplies to flush faucet bidet
and replace aerator prior to using faucet bidet.
Debris remaining in the line will
damage lavatory bodies and cause leaking.
Failure to flush the lines could result in
voiding the warranty.
-Connect flex lines to your
angle stops.
Connect flex lines to water supply:
NOTE: Due to sediment in the water it may
be necessary on occasion to remove the aerator
and clean the screen with a soft bristle toothbrush.
Please refer to Finish Care Instructions for complete
cleaning information. Wipe frequently with a soft, damp
cloth. Never use acids, harsh abrasives or detergents
.
IMPORTANT CLEANING NOTICE
Install pop-up assembly.
-Separate drain collar from pop-up assembly.
-Apply silicon caulking to underside of drain collar. NOTE: Do not use
"Plumbers Putty" or any oil based sealants! Use of anything other than
silicon caulking will VOID the finish warranty.
-Insert drain body from underside through sink. Slowly screw on drain
collar, align with ball rod hole facing back wall, then gently pull down into
sink and firmly tighten brass nut from below.
-Remove tailpiece from drain body and apply teflon tape, approx. 3 to
5 wraps around threads and reinstall into bottom of drain body.
-Insert stopper in collar and hold with eye-screw hole facing back.
If necessary, adjust stopper eye-screw height by loosening lock nut and
rotating counter-clockwise. Tighten lock nut (See Fig. 9).
-Remove spring clip from ball rod.
-Remove nut and cone washers and slide onto end of ball rod.
-Insert ball rod into drain body below so short end of ball rod end fits
in stopper eye-screw hole. Snug ball rod nut (do not over tighten).
Ball rod must move up & down freely (See Fig. 9).
-Insert lift rod through top of spout and then through hole rod strap
underneath sink. Tighten thumb-screw of hole rod strap
against lift rod and connect to ball rod by gently pinching locking
spring clip and sliding one side of spring clip onto ball rod.
-Insert hole strap onto ball rod, then pinch spring clip together to fit
on ball rod.