Brookfield Bath, Model TC-101 User Manual
Page 2

3
Table of Contents
Section 1. General Information
1.1 Unpacking
1.2 Package Contents
1.3 Description of Circulating Baths
1.4 Specification Chart
Section 2. Set Up
2.1 Location
2.2 Filling the Reservoir
2.3 Reservoir Fluids
2.4 Fluid Connections
2.5 Pump
2.6 Open Bath Circulation
2.7 Closed Loop Circulation
2.8 Power Supply
Section 3. Programmable Controller
3.1 To Set Temperature
3.2 To Change Pump Speed
3.3 System Set Up
— Adjust Display Contrast
— Set Temperature High & Low Limits
— Change Readout - °C, °F, °U
— Change Resolution - .1°, .01°, .001°
— External Probe
— Function Tuning
(Pump Speed and Controller Optimization)
— Pump Speed Selection
— Fluid Volume
— Flow Rate
— Specific Heat
— °U Cal, User Defined Temperature Scale
— RS232
— Auto Refrig
3.4 Setting the Safety Thermostat
Section 4. Programming
4.1 Writing A Program
4.2 Entering A Program Into Memory
4.3 Running A Program
Section 5. Maintenance
5.1 Heater
5.2 Pump Motor
5.3 Condenser and Air Vents (Refrigeration Units)
5.4 Cleaning
5.5 Maintaining Clear Bath Water
Section 6. Troubleshooting
6.1 Unit Disabled, Service Required
6.2 No Pumping or Insufficient Pumping
6.3 No Cooling or Insufficient Cooling
6.4 No Heating or Insufficient Heating
6.5 Triac Failure
6.6 Default Settings
Section 7. After-sale Support
Section 8. Warranty