Aviom Aviom16/o-Y1 - Manual (Page 16)

9 Y1 A-N
et
C
Ard
U
ser
G
Uide
Installing the Y1 Card
The Y1 card can be used in any open MY expansion slot in a Yamaha digital mixing console or mix engine
device. The number of available expansion slots varies with each model. In the Yamaha user interface, the
MY expansion slots are identified by number, starting with “1.”
Align the card with the support guides in the expansion slot.
To install the Y1 card:
Start with the power to the Yamaha mixing console off. •
Remove the console’s power cord from the wall receptacle. •
Remove the cover plate on the rear of the Yamaha expansion port to expose the •
expansion connections.
Remove the Y1 card from its protective anti-static sleeve.
•
Slide the card into place, aligning the sides of the card with the support guides in the •
expansion slot.
Press the Y1 card firmly in place to attach the multi-pin card connectors on the Y1 card
•
and Yamaha mixer circuit board backplane.
Attach the Y1 card permanently by tightening the two thumb screws on the rear panel of
•
the Y1 card.
Connect the Y1 card to other Pro16 A-Net devices using Cat-5e (or better) UTP cables.
P N
ote
: Before powering up the console, read the following sections on operating modes.