Aviom A-16II User Manual
Page 44

36
A-16ii P
ersonAl
M
ixer
U
ser
G
Uide
Problem: In Group mode, can’t select a new channel.
Possible Solutions:
If you already have three Groups defined and attempt to create a new Group, the button
•
press is ignored. Creating a new Group would exceed the limit of three Groups per Preset.
Edit or delete an existing Group to continue.
Problem: Mono line-level output is weak
Possible Solutions:
If you connect the TRS output of the A-16II Personal Mixer to a balanced mono powered
•
speaker, you must use a properly configured cable. Using a TRS-to-XLR cable to connect
to the balanced input of a device will cause the left and right sides of the A-16II mix to be
subtracted from each other resulting in a loss of signal level.
Use a TS-to-XLR cable instead; wire the tip of the TS plug to pin 2 of the XLR; connect
•
ground from the TS plug to XLR pins 1 and 3.