Held solo mode – Aviom A-16II User Manual
Page 29

21
A-16ii P
ersonAl
M
ixer
U
ser
G
Uide
to hear alone. Its red button LED should be lit. Now press the S
OlO
button, found in the pair of buttons in
the upper right corner of the Personal Mixer. The channel is now heard solo.
You can make changes to volume and panning when a channel is in Solo mode. All changes happen
immediately. Consider Solo mode as a temporary state only. You cannot save a Preset with a channel in
Solo mode.
Only one channel, linked pair, or Group can be in solo at a time. To exit Solo mode, simply select another
channel or press the S
OlO
button again to exit.
To select a different channel for auditioning in Solo mode, remember that you must first select a channel
and then press the S
OlO
button to enter Solo mode.
Two solo modes are available, indicated with a solid or flashing LED in the button.
Held Solo Mode
This Solo mode allows channels to be isolated in succession without exiting the Solo Mode. This is in
addition to the regular Solo Mode behavior described above that allows the user to exit Solo Mode by
pressing any other interface button after soloing a channel. Held Solo Mode is indicated by the flashing of
the Solo LED.
To use Held Solo Mode, you must start from Mix Mode (that is, no channels are currently soloed). The
Recall, Group, and Solo LED’s should be off.
To use Held Solo Mode:
Press and
•
hold the S
OlO
button.
While holding down the
•
S
OlO
button, press and then release any channel button.
You can now release the
•
S
OlO
button. (If you release the S
OlO
button before releasing the
channel button, Held Solo will not be engaged.)
The channel that you pressed is now soloed, and the Solo LED is flashing.
•
To solo another channel, press its channel button.
•
To exit Held Solo Mode, press the
•
S
OlO
button again.