Operator’s manual – ANKOM RF User Manual
Page 16
Operator’s Manual
pg. 16
Rev F 8/29/14
(9)
When the message box above shows that the installation is complete, click the
Next> button and the
following message box is displayed.
(10) If you want to immediately start the GPM software, then ensure that a check mark () is in the box next
to
Run Gas Pressure Monitor x.x.x.x (this refers to the specific version of software that you are
installing) in the message box above. If it is not checked and you want it to be, then click the check box.
(11) To complete the installation, click the
Finish button in the message box above.
After executing the Software Installation procedure detailed above, the GPM program is installed on your
computer and the following GPM icon is placed on your desktop.
Before running your GPM software, plug the Base Coordinator into a USB
port on your computer so the necessary drivers can be installed.
To use the GPM software, double-click the GPM icon on your computer desktop.