360 Systems MAXX-1000SD - Manual (Page 38)

Page 38 MAXX Owner’s Manual
Setting the Time Code Source
This function selects the time code source for newly recorded clips. A time code value is obtained
from the selected input source at the start of a new recording. Refer to Figure 6. Choose VITC, LTC
or Manual input source. For MANUAL, enter the desired time value for the first frame of the
recording in the Starting Time Code entry field.
Beginning Recording
When the steps outlined above in “Setting up for Recording” are done, you are ready to record.
Place Channel 1 in the Record Ready mode as follows.
A. From the Channel 1 Transport Window, Select FILE>NEW. The dialog of Figure 7 appears.
Figure 7 - Channel 1 Clip Navigator "New" mode
B. Note the Folder Structure in the FOLDERS window to the left. If you have not added any
folders (Refer to Creating Folders on Page 52) no folders will be shown. If you have already
created a folder structure you can select the destination folder for your clip at this time by
clicking on the folder you want it to be placed in. You can always move or copy it later as well.