360 Systems MAXX2400HD - Manual (Page 54)

MAXX-2400HD Owner’s Manual Page 53
Programming GPI Inputs
The MAXX-2400HD has 12 General Purpose Inputs, referred to as GPI 1 through GPI 12. Each can
be programmed to trigger one of the following events on a channel:
CUE Cue a clip
JUMP Cue selected clip for immediate playback (Playlist Mode only)
NEXT Immediately plays next cued clip in a playlist for playback (Playlist
Mode only)
PAUSE Pause a clip
PLAY Play a clip
RECORD Start a recording
SELPREV In Playlist Mode – Navigate to clip above currently selected clip
SELNEXT In Playlist Mode – Navigate to clip below currently selected clip
STOP Stop a clip
To program a GPI Input, select EDIT->CONFIGURE->GPI. Figure 17 will display the screen. GPI 1
through 12 are programmable inputs. The checkboxes to the right of each selection represent video
channels 1, 2, 3 and 4. GPI 9 is shown with an expanded pulldown for trigger option.
1. To activate a GPI input, select the event from the pulldown the event menu
2. Mark a checkbox for the channel of interest. The event will be triggered when that GPI goes
active.
3. Click APPLY to activate.
Figure 17 - GPI Configuration Screen