360 Systems MAXX2400HD - Manual (Page 41)

Page 40 MAXX-2400HD Owner’s Manual
Setting the Audio Input Source
Select OPTIONS->CONFIGURE from the Channel 1 Transport Window. The Dialog box in Figure
10 appears.
• Select an Audio Input by clicking the desired button.
• Click APPLY or OK.
Embedded audio is eight tracks contained in the HD-SDI video stream.
AES/EBU Digital Audio refers to audio input from the optional DXP-1 multi-channel module.
Analog Audio refers to audio input from the optional AXP-3 and AXP-4 multi-channel module.
Arming Audio Tracks
Select OPTIONS->CONFIGURE from the Channel 1 Transport Window.
Refer again to Figure 10 - Channel Configuration Dialog. Under TRACK ARM, Check AUDIO if
recording audio is desired. All eight tracks are recorded.
Click APPLY or OK
Setting an Audio Delay Time
Audio tracks can be offset from video in 1 millisecond increments up to +/- one second. The setting
is per channel and non-volatile. It applies to playback only, not recording.
You must stop and start the playback to hear the result of a change. This adjustment is made in
Transport mode; once set it also applies to Playlist mode on that channel.
Select OPTIONS->CONFIGURE from the Channel Transport Window. The Dialog box in 10
appears.
Click the OUTPUT tab.
Enter a time offset value in the window.
Click APPLY or OK.