MagnaFlow DODGE DIESEL CUMMINS, 5in. HIGH-OUTPUT Aluminized Pro Series Diesel PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation) To remove the OEM exhaust
system, you will need to loosen or remove the
clamps that fasten the system together, including
the V-band clamp at the turbocharger. You can
then disengage any welded hangers from the
OEM rubber insulators and extract the system
from the vehicle.
Step 2: Before installing the new downpipe, you
will need to temporarily remove the hanger
bracket on the bellhousing that attaches to the
downpipe hanger as shown in Diagram 2. Install
the new downpipe by fitting the OEM hanger
bracket onto the downpipes welded hanger, then
remount the hanger bracket and turbocharger
V-band clamp. Leave all clamps and fasteners
loose for final adjustment of the complete
system. CC/SB and EC/LB trucks will use the
39.5" extension pipe only. CC/LB trucks will
need to add the 25" extension pipe between the
downpipe and 39.5" extension pipe. Install the
required extension pipes, muffler, and tailpipe
pieces by fitting the welded hangers into the
OEM rubber insulators, and by fastening the
pipes together using the supplied 5" clamps.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
18989
2004 - Dodge Ram HO Diesel 5.9L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Nov 19, 2012
Rev: 000
Downpipe
39.5" Pipe Assy.
25" Pipe
Muffler
Tail Pipe Extn. Assy.
Tail Pipe
[5] 5.00" Clamps