MagnaFlow FORD DIESEL 6.4L DIESEL, 4in DUAL Aluminized Pro Series Diesel PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation)
Loosen the band clamp fastening the
muffler assembly to the particulate filter. You can
now disengage the welded hangers from the rubber
insulators and remove the exhaust system from the
vehicle. Do not damage the OEM rubber insulators,
as they will be reused to mount the new system. You
may also cut the tailpipe behind the muffler to aid in
removal of the system.
Step 2: Install the 8" inlet pipe making sure the
alignment notch fits around the peg on the filter
outlet pipe using the supplied 3.50" clamp. Leave all
clamps loose for final adjustment of the complete
system. CC/LB models require the 20" extension
pipe, shorter models will now use the delete pipe and
4.00" clamps. Install the tailpipe extensions and
tailpipe assembly in a similar fashion using the
supplied 3.50" clamps and by fitting the welded
hangers into the rubber insulators.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and
clearance of frame & bodywork. (MAGNAFLOW
recommends at least 1/2" of clearance between the
exhaust system and any body panels to prevent
heat-related body damage or fire.)
Step 4: Once a final position has been chosen for
the new system, evenly tighten all fasteners from
front to rear. The supplied band clamps must be
VERY tight to properly align the pipes and prevent
leaks (Approximately 40ft-lbs). U-bolt clamps should
be tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and
retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
18988
2008 - Ford F-Series Super - Duty 6.4L V8
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Nov 28, 2012
REV: 000
8" PIPE
20" PIPE
DELETE PIPE
Y-PIPE
TAILPIPE EXTENSIONS
TAIL PIPE
3.50" CLAMP
4.00" CLAMP
3.50" CLAMP
4.00" CLAMP
4.00" CLAMP
3.50" CLAMP
3.50" CLAMP
3.50" CLAMP