MagnaFlow FORD DIESEL 7.3L DIESEL, 5in Aluminized Pro Series Diesel PERFORMANCE EXHAUST - Manual (Page 2)

Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. You can now
reinstall the transfer case shield and stabilizer bar.
Refer to Ford's shop manual for proper torque
specifications of all mounts. Inspect all fasteners after
25-50 miles of operation and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
18907
1993 - 2003 Ford F-250 / F-350 - 7.3L Turbo Diesel "Dually"
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Nov 19, 2012
Rev: 000
DIAGRAM 2
DIAGRAM 3
DIAGRAM 3
DIAGRAM 4
UPPER BOLT
LOWER BOLT