MagnaFlow DODGE DIESEL CUMMINS, 5in. HIGH-OUTPUT Aluminized Pro Series Diesel PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions
before installation)
To remove the OEM system,
you will need to cut the tailpipe just behind the OEM
muffler. Working front to rear remove the OEM
system rearward of the DPF. Disengage the welded
hangers from the rubber insulators and undo all
attaching clamps. Do not damage or discard the
OEM rubber insulators as they will be reused to
mount your new magnaflow system.
Step 2: Begin by attaching the Inlet pipe assembly
to the outlet of the DPF using a suppled 4.00" clamp
and by fitting the hangers into the OEM rubber
insulators. (all clamps are to be left loose for final
adjustment of the system). Finish by attaching the
Mid-Pipe and Tail Pipe Assembly in a similar fashion
using the supplied 5.00" clamps and fitting the
hangers.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and
clearance of frame & bodywork. (MAGNAFLOW
recommends at least 1/2" of clearance between the
exhaust system and any body panels to prevent
heat-related body damage or fire.)
Step 4: Once a final position has been chosen for
the new system, evenly tighten all fasteners from
front to rear. The supplied band clamps must be
VERY tight to properly align the pipes and prevent
leaks (Approximately 40ft-lbs). Inspect all fasteners
after 25-50 miles of operation and retighten if
necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
18904
2013 Dodge 2500HD/3500 6.7L
Warning : When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
JULY 11, 2013
Rev: 000
Mid-Pipe
Inlet Pipe
Assy
Tail Pipe
Assy
[2] 5.00"
Clamp
4.00"
Clamp