MagnaFlow DODGE DIESEL CUMMINS, 5in. HIGH-OUTPUT Pro Series Diesel PERFORMANCE EXHAUST - Manual

Step 1:(Carefully read all instructions before
installation)
To remove the OEM system, you will
need to cut the tailpipe just behind the OEM muffler.
Working front to rear remove the OEM system.
Disengage the welded tailpipe hangers from the
rubber insulators and undo all attaching clamps. Do
not damage or discard the OEM gasket, fasteners, or
rubber insulators, as they will be reused to mount
your new MAGNAFLOW performance exhaust
system.
Step 2: Install your new system by first mounting the
inlet pipe assembly to the OEM inlet extension pipe
using the supplied 4" clamp. Then install the mid
pipe and tail pipe assembly in a similar fashion using
the suplied 5" clamp. Locate all welded hangers to
the rubber isolators.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
17950
2013 Dodge 2500HD/3500 6.7L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
07/11/13
Rev: 000
TAILPIPE ASSY
[2] 5.00"
CLAMPS
4.00" CLAMPS
INLET ASSY
MID PIPE