MagnaFlow DODGE TRUCK RAM 1500 TRUCK Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation) Unbolt the clamp attaching the OEM inlet
pipe to the catalytic converter extension pipe. Unbolt
the OEM clamps fastening the muffler and tail pipe
assemblies. The OEM system can now be removed
by disengaging the welded hangers from the OEM
rubber isolators (Do not damage the OEM rubber
isolators, as they will be reused to mount the new
system.)
Step 2: Fasten the Inlet Pipe to the catalytic
converter extension pipe using the supplied 3.00"
clamp assembly. Be sure to engage the location slot
to the peg in the OEM pipe. Install the muffler
assembly, and tip in the same fashion using the
supplied 2.50"clamps. Leave all clamps and
fasteners loose for final adjustment of the complete
system.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 65ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
17116
2008 Dodge Ram 1500 MC IFS 5.7L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Sept 30, 2010
Rev: 000
3.00" Tip
3" Clamp
2X 2.5" Clamps
Inlet Pipe Assy.
Muffler Assy
Locating Notch