MagnaFlow RAM TRUCK 1500 Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation) To remove the OEM system, unbolt the
tailpipe and muffler assemblies. Disengage the
welded hangers from the OEM rubber insulators,
taking care not to damage them.
Step 2: Begin installation of the new system by
fastening the inlet Pipe to the catalytic converter
extension pipe using the supplied 3.00" clamp (Be
sure to line up the large notch in the pipe with the
alignment peg or the system will not fit properly).
Leave all clamps and fasteners loose for final
adjustment of the complete system. Install the Muffler
Assembly and Tail Pipe in a similar fashion, using the
supplied clamps as shown in the diagrams.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be very tight to
properly align the pipes and prevent leaks (Approx.
40ft. lbs.). Inspect all fasteners after 25-50 miles of
operation and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
17108
2009-2014 Dodge Ram 1500 5.7L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Nov 21, 2013
Rev: 001
Inlet Pipe
Muffler
Assembly
Tail Pipe
3.00" Clamp
2.50" Clamp
2.50" Clamp