MagnaFlow FORD TAURUS Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1:(Carefully read all instructions before
installation) Start the removal process of the OEM
exhaust system. First measure and cut both OEM
inlet pipes 4.75" rearward of the catalytic converter.
Working front to rear carefully remove all hangers
from the rubber isolators and remove the system.
Step 2: Begin the installation of your new
MAGNAFLOW Performance Exhaust System by first
laying out all components to check content and
orientation. Slip the inlet of the Inlet Pipe over the
passenger side outlet pipe from the catalytic
converter that you have cut. Loosely secure using
the supplied clamp. Next slip the inlets of the Inlet
Muffler Assembly over the cut inlet pipe and the new
Inlet Pipe. Loosely secure using the supplied clamps.
Mount both Mid Pipe Assembies by slipping each
inlet over the Inlet Muffler Assemblies outlet pipes.
Locate hangers into rubber isolators and loosely
secure using the supplied clamps. Mount both Tail
Pipe Muffler Assemblies by slipping each inlet over
the Mid Pipe Assembies outlet pipes. Locate
hangers into rubber isolators and loosely secure
using the supplied clamps.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 65ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15769
2010 Ford Taurus 3.5L SHO Dual Split Rear Exit
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Apr 2, 2010
Rev: 000
INLET PIPE
INLET MUFFLER ASSY.
D/S MID PIPE ASSY.
P/S MID PIPE ASSY.
D/S MUFFLER TAIL ASSY.
P/S MUFFLER TAIL ASSY.
2X 2.25" Clamps
5X 2.50" Clamps