MagnaFlow LINCOLN TRUCK MKT Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions
before installation)
Begin removal of the OEM
exhaust system by unbolting the clamp where the
catalytic converter extension meets the inlet of the
muffler and remove the system from the OEM
insulators. Be careful not to damage the OEM rubber
insulators, as they will be re-used to mount the new
system.
Step 2 : Install the new system by sliding the inlet
of the Resonator Assembly over the catalytic
converter extension, and by fitting the welded hanger
into the OEM rubber insulator. Use the supplied 2.25"
clamp to fasten the Resonator Assembly to the
catalytic converter extension, leaving all fasteners
loose for final adjustment. Install the Y-pipe and
Muffler assemblies in a similar fashion using the
supplied 2.50" clamps, and fitting the welded hangers
into the OEM rubber insulators.
Step 3 : With all components mounted loosely,
adjust the system for overall aesthetics and clearance
of frame & bodywork. (MAGNAFLOW recommends
at least 1/2" of clearance between the exhaust
system and any body panels to prevent heat-related
body damage or fire.)
Step 4 : Once a final position has been chosen for
the new system, evenly tighten all fasteners from
front to rear. The supplied band clamps must be
VERY tight to properly align the pipes and prevent
leaks (Approximately 40ft-lbs). Inspect all fasteners
after 25-50 miles of operation and retighten if
necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15467
2011 Ford Explorer 3.5L
Warning : When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500 06/16/11
Resonator
Assy
Y-pipe
Assy
D/S Muffler
Assy
P/S Muffler
Assy
2.25" Clamp
[3] 2.50" Clamp