MagnaFlow FORD DIESEL 6.7L DIESEL, 5in MagnaFlow Diesel Performance PERFORMANCE EXHAUST - Manual

Step 1: Begin by unfastening the OEM exhaust
from the Diesel Particulate Filter (DPF) at the 3
bolt flange and remove the EGT sensor. You
can now disengage the welded hangers from
the rubber insulators and remove the exhaust
system from the vehicle. Do not damage the
OEM rubber insulators, as they will be reused to
mount the new system. You may also cut the
tailpipe behind the muffler to aid in removal of
the system.
Step 2: Install the flanged inlet pipe to the
catalytic converter outlet. Crew Cab and Long
Bed (CC/LB) models require the 19" Extension
Pipe, shorter vehicles will now use the Muffler
Assembly or the Muffler Delete Pipe and
appropriate clamps. Leave all clamps loose for
final adjustment of the complete system. Install
the Mid-pipe Assembly and tailpipe in a similar
fashion using the supplied 5.00" clamps and by
fitting the welded hangers into the rubber
insulators. Re-install the EGT sensor.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and
clearance of frame & bodywork. (MAGNAFLOW
recommends at least 1/2" of clearance between
the exhaust system and any body panels to
prevent heat-related body damage or fire.)
Step 4: Once a final position has been chosen
for the new system, evenly tighten all fasteners
from front to rear. The supplied band clamps
must be VERY tight to properly align the pipes
and prevent leaks (Approximately 40ft-lbs).
U-bolt clamps should be tightened to
approximately 30-35ft-lbs. Inspect all fasteners
after 25-50 miles of operation and retighten if
necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15350
2011-2015 Ford F-Series 6.7L Diesel
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
05/22/14
Rev. 000
INLET PIPE
MUFFLER DELETE
PIPE
MUFFLER
ASSY
EXTENSION
PIPE
TAIL PIPE
ASSY
2X 4.0" CLAMP
2X 5.0" CLAMP
EGT SENSOR BOSS