MagnaFlow FORD TRUCK F-100 Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

BILL OF MATERIALS:
SHOP SUPPLIES:
MINIMUM REQUIRED TOOLS:
To ease removal of existing exhaust components
(especially on older vehicles) spray penetrating lubricant
on all fasteners and hangers/insulators that will be
loosened or removed and let soak before disassembly.
SPRAY LUBRICANT
WEAR SAFETY
GLASSES
READ INSTRUCTIONS
THOROUGHLY BEFORE
INSTALLING PRODUCT
MAGNAFLOW RECOMMENDS PROFESSIONAL INSTALLATION ON ALL THEIR PRODUCTS
WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle's
exhaust system to cool before removal, as exhaust system temperatures may cause severe burns. If working
without a lift always consult vehicle manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
ATTENTION: Always install any supplied band or U-bolt clamps to the proper torque specifications of 40-45
ft-lbs for band clamps and 30-35 ft-lbs for U-bolt clamps. Over tightening will result in the clamp breaking and
will NOT be warranted by MagnaFlow.
MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
15mm
13mm
PART NO. 15339 '48 - '52 FORD F-100 3.7L
HARDWARE KIT:
1.[8] 2.50" Clamp
2.[2] Bolt 3/8-16x1.50"
3. [2] Nut 3/8-16"
4. [4] Nut 7/16-14"
5. [2] Washer 3/8"
6. [4] Washer 1/2x1.50"
7. [2] Threaded Hanger 7/16-14"
8. [2] Hanger Rubber
9. [2] Rubber Snap Grommet
1. [2] INLET PIPE
2. X-PIPE ASSY
3. MUFFLER ASSEMBLY D/S
4. MUFFLER ASSEMBLY P/S
5. OVER AXLE PIPE ASSY D/S
6. OVER AXLE PIPE ASSY P/S
7. [2] TAIL PIPE
8. [2] TURN-DOWN TIP
Hanger Tool
(Or Pry Bar) Sawzall or similar
cutting tool
Power Drill
1
1
2
3
4
5
6
7
7
8
8