MagnaFlow FORD TRUCK F-150 Stainless Cat-Back System PERFORMANCE EXHAUST - Manual (Page 2)

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 1. To remove the OEM exhaust system, you
will to need to cut the pipe beind the muffler before it
goes over the axle. You can then disengage the
welded hangers from the OEM rubber insulators
and remove the tailpipe
. Un fasten the clamp
attaching the OEM muffler inlet to the OEM catalytic
converter. Do not damage or discard the OEM
fasteners or rubber insulators, as they will be reused
to mount the new system. Disengage the muffler
hangers and remove the OEM exhaust from the
vehicle
.
Step 2. To begin, fasten the Inlet Pipe Assembly
to the catalytic converter using the OEM clamp
assembly and by fitting the welded hanger into the
OEM rubber insulator (Leave all clamps and
fasteners loose for final adjustment of the complete
system.) Install the Muffler to the Inlet Pipe
Assembly using the supplied 3.00" clamp. Next
install the Tailpipe Extensions to the Muffler in the
similar fashion using the supplied 2.50" clamps.
Step 3. Next you will need to use the supplied
U-Nuts and attach them to the recieving cut outs in
the bottom of the frame rail. Fasten the supplied
hanger assemblies to the frame members using the
supplied bolts on both the Driver and Passenger
side. Install the Tail Pipe Assemblies to the Tail Pipe
Extensions using the supplied 2.50" clamp, fitting
the welded hangers into rubber insulators.